- Product Description
-
Simple series PROFINET module
Profinet switch function
Supports RT mode, log storage,
and firmware upgrade for
network ports
Expanded up to 16 modules.
- Technical Spec
-
Model CTSI-PNT-00C1 Function Overview Function Category Function Item Description External Interface Function Expansion bus interface Provides 1*expansion module interface, which can connect up to 16 Simple series I/O modules PROFINET Interface Provides 2*PROFINET communication interfaces Isolation Function Power Isolation Isolation between external power supply and system power supply Interface Isolation Isolation for PROFINET communication interfaces Protection Function Power Protection The power supply terminal provides reverse polarity protection and surge absorption function Physical Characteristics Dimensions（W×H×D） 24×104×80 mm IP Rating IP20 Power Supply Specifications Rated Input Voltage 24V DC Input Voltage Range 20.4V~28.8V DC Input Current 1A Input Power Protection Supports reverse polarity protection LED Indicator Characteristics Note 1: Blinking = Flashes once every 200 milliseconds. PWR Indicator Green ON = 24VDC power supply is normal OFF = No 24VDC power supply SF Indicator Red ON = Mismatch between configured modules and actually connected modules, or expansion I/O bus fault (e.g., expansion module not found) Blinking = Module error message (e.g., disconnection, over-range, no module power supply) OFF = No fault BF Indicator Red ON = PROFINET bus communication fault (e.g., not connected to switch, no network detected) OFF = No fault MT Indicator Yellow Reserved (Maintenance Indicator) RJ45 Port Indicator Green ON = Connected to switch/PN master OFF = Not connected to switch/PN master Yellow ON = Data transmission/reception to/from switch/PN master OFF = No data transmission/reception to/from switch/PN master Expansion I/O Capability Maximum number of modules per slave station 16 Protocol type Simple series PLC custom 100MHz bus protocol Module hot-swappable function Not supported PROFINET Communication Port Communication interface 2*single RJ45 ports Communication mode Supports RT, minimum communication cycle 1ms Does not support IRT Communication rate Ethernet service transmission rate: 100 Mbps PROFINET transmission rate: 100 Mbps Communication method Full duplex PROFINET protocol version V2.4 PROFINET switch function Supports networking function Supported Ethernet services Supports ping, arp, network diagnosis (SNMP/MIB-2, LLDP) Alarm/Diagnosis/Status Information Supported. The local PN bus uploads error codes (e.g., disconnection, over-range) to the PN master. The coupler supports uploading logs (e.g., chip crash feedback) via MagicWorks. Physical Layer 100BASE-TX Topology Supports line, star, and tree topologies Does not support ring topology Transmission Medium Cat 5e or higher Transmission Distance < 100 meters between two nodes No configuration required for device replacement Supported (for the same type of PN module) Main unit factory reset Supported via Ethernet connection to MagicWorks; supports independent restoration of IP address and coupler name Module factory reset Not supported Main unit firmware upgrade Supported (via Ethernet port upgrade) Hardware Configuration Function Imported file type PROFINET GDS file (XML format) Third-party PN master Added Simple series PN modules support 16-slot expansion Expansion modules can add Simple series I/O modules
- Installation
